Today's work on the workbench was all about the end cap. I marked out the pins then took the cap over to the drill press to drill the counter bores and through hole for the end vise. Safety first! using a router to hog out the pins works very quickly and only leaves you a small bit of wood to clean out of the corners by hand with chisels. Here we have the LAST piece of the top glued on and most of the leg vise hardware installed. I'm hoping to be done with the bench by Saturday night!!!!!
1 Comment
|
AuthorGoogle told me that if I started a blog my page ranking would go up! So here it goes. Archives
March 2016
Categories |